Ensure that the surface is clean and dry.Pail of water (0.5 liters) for activating Wrap Seal PLUS Fiberglass Repair TapeĬorrosion Repair and Reinforcement Procedure: Cleaning fluid: Solvent-based degreaser for cleaning surfaces Paint brushes for application of Wrap Seal PLUS Resin and Activator Personnel protection: safety glasses, hand equipment gloves, face mask/ self-breathing apparatus, etc. course files, sand papers, saw (blades, wire brush, etc.) Surface preparation tools: Mechanical power tools or hand tools (e.g. Corrosion Repair & Reinforcement For Pipes It is assumed that this is a simple pipe corrosion repair without any leaks.Materials Required for Repair:1. After curing, the product will cure rock hard and adhere strongly onto the pipe. It is used for wrapping around pipes to re-mediate and reinforce and thereby improve pipe integrity. Wrap Seal PLUS Fiberglass Repair Tape is coated with polyurethane resin that will react and cure once in contact with water. Avoid prolonged breathing of vapors from uncured material. Should skin contact occur, wash with non-abrasive soap and water. Prolonged skin contact with uncured material may cause skin irritation. Handle uncured product with gloves provided. Flush eyes with plenty of water and seek immediate medical attention. Wrap Seal PLUS Fiberglass Repair Tape may cause eye irritation. when wrapping Wrap Seal PLUS Fiberglass Repair Tape on steam or high temperature pipes), dip the Wrap Seal PLUS Fiberglass Repair Tape into icy cold water to gain extra working time. On the contrary, if longer curing time is required (e.g. If faster curing is required, heat up the surface slightly to shorten curing time. Instead, spray the pipe wrap heavily with water as these large product sizes are wrapped around the pipe.Īllow curing in accordance to the minimum curing time at room temperature before operation. 4” x 20’, 4” x 30’, 6” x 20’ and 6” x 30’) do not dip the entire fiberglass repair tape into water as there will not be sufficient working time to wrap the entire roll. Apply the entire roll of pipe wrap over the pipe surface with at least 50% overlap for the entire pipe repair length.Ĭuring time of Wrap Seal PLUS Fiberglass Repair Tape is 1 minute after being in contact with water. As the fiberglass repair tape is wrapped, spray the tape with water. Wrap the pipe as tightly and evenly as possible, pulling slightly after each round of wrapping. Wrap Seal PLUS Fiberglass Repair Tape specially designed for repairing pipes with straight section, elbows, t-joints,reducers, flanges, valves, etc. Wrap Seal PLUS Fiberglass Repair Tape is a polyurethane coated pipe wrap which uses to reinforce thinning pipe wall thickness and increase dimensional stability caused by corrosion, thereby bringing the pipeline back to its design operating pressure. Pipe Wrap: Wrap Seal PLUS Fiberglass Repair Tape
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |